GW Instek LCR-6100 - Monitor 1 and Monitor 2 [MON 1][MON 2]

Setup Key
56
To set up the Auto LCZ Function
Step 1. Press the [Setup] key
Step 2. Use the cursor key to select [AUTO LCZ] field
Step 3. Use the soft-keys to turn on/off the Auto
LCZ Function.
Soft-key
Function
OFF
Turn off the Auto LCZ Function
ON
Turn on the Auto LCZ Function.
When Auto LCZ Function is set to ON,
“AUTO-LCZ” will display on [FUNC]
field.
NOTE
The Auto LCZ Function will be turned off after you
set the measurement function.
5.1.5 Monitor 1 and Monitor 2 [MON 1][MON 2]
The LCR-6000 Series can monitor the other two
parameters.
NOTE
Additional monitoring parameters do not
increase the instrument measurement time.
Monitor parameter display in [MEAS DISPLAY]
page and [ENLARGE] page.
Procedure for setting monitor parameters (monitor 1
and monitor 2)
Step 1. Press the [Setup] key.
Step 2. Use the cursor key to select [MON 1] or
[MON 2] field.
Step 3. Use the soft-keys to select DC bias voltage.
Soft-key
Function
OFF
Turn off the monitor
Z
Absolute value of impedance
D
Dissipation factor
Q
Quality factor(=1/D)
Vac
Test signal Voltage
Iac
Test signal Current
Δ
Absolute deviation value
Δ%
Relative deviation value
θr
Phase radian