GW Instek LCR-6100 - Remote Control (Continued); To Select Baud Rate

LCR-6000 Series User Manual
53
In the [MEAS SETUP] Page, you can configure each of
the following measurement controls with the cursor
placed in the corresponding field.
 Measurement Function [FUNC]
*1
 Impedance range [RANGE]
*1
 Test Frequency [FREQ]
*1
 Trigger Mode [TRIG]
*1
 Test Signal Voltage Level [LEVEL]
*1
 Measurement Speed [SPEED]
*1
 Source Output Impedance [SRC RES]
 Averaging Factor [AVG]
 DC Bias Voltage [BIAS]
 Auto LCZ Function [AUTO LCZ]
 Monitor 1 and Monitor 2 Parameter Select [MON 1]
[MON 2]
 Measurement Delay Time [DELAY]
 Auto Level Control [ALC]
NOTE
*1. These six settings can be set in the
[ MEAS DISPLAY] page and the [ BIN COUNT]
page. Please refer to section 4.1 [MEAS DISPLAY]
Page on page 24 for details.