GW Instek PSU 6-200 - How to Use the Instrument

OPERATION
45
How to Use the Instrument
Background
The PSU power supplies use a novel method of
configuring parameter values only using the
voltage or current knobs. The knobs are used to
quickly edit parameter values at 0.01, 0.1 or 1
unit steps at a time.
When the user manual says to set a value or
parameter, use the steps below.
Example
Use the Voltage knob to set a voltage of 10.05
volts.
1. Repeatedly press the Voltage knob
until the least significant digit is
highlighted. This will allow the
voltage to be edited in 0.01 volt
steps.
2. Turn the Voltage knob till 0.05
volts is shown on the voltage
display.
Voltage
Voltage
AV
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
3. Repeatedly press the Voltage knob until the
most significant digit is highlighted. This will
allow the voltage to be edited in 1 volt steps.
4. Turn the Voltage knob until 10.05 is shown.
AV
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C