To Next Page

To Previous Page

4-8

CPU Clock Speed : 200MHz

BUS Clock Speed : 33MHz

Memory Size : 64MB

Mac Address : 000fe20f3100

Press Ctrl-B to enter Boot Menu... 5

In normal startup mode, the waiting time here is five seconds. If you press <Ctrl+B> within five seconds,

the Boot Menu is displayed. If you perform no operation or press a key other than <Ctrl+B> within five

seconds, the system begins to automatically start up and the following information is displayed:

Auto-booting...

Decompress Image...................................................

...................................................................

...............................................OK!

Starting at 0x80100000...

Initialize LS41LTSGB0......................OK!

SDRAM fast selftest........................OK!

Flash fast selftest........................OK!

Switch chip selftest.......................OK!

Slot 1/1/1 has no module

PHY selftest...............................OK!

Please check port leds...............FINISHED!

User interface aux0 is available.

Press ENTER to get started.

The appearance of "Press ENTER to get started" indicates that the switch finishes the auto-startup.

Press <Enter>, and the following prompt is displayed:

<H3C>

You can configure the switch now.

The H3C S3100 Series Switches provides abundant command views. For detailed descriptions about

the configuration commands and CLI, refer to H3C S3100 Series Ethernet Switches Operation Manual

and H3C S3100 Series Ethernet Switches Command Manual.

H3C S3100 Series Installation Manual

Other manuals for H3C S3100 Series