5-11
Step 3: Update the host program on the switch.
<H3C> boot boot-loader s3100-SI.bin
<H3C> display boot-loader
Unit 1:
The current boot app is: s3100-SI.bin
The main boot app is: s3100-SI.bin
The backup boot app is:
Step 4: Restart the switch.
<H3C> reboot
Before restarting the switch, make sure other configurations are all saved to avoid the loss of
configuration information.
After the above operations, the Boot ROM and host software loading is completed.
Pay attention to the following:
z Host software loading takes effect only after you restart the switch with the reboot command.
z If the space of the flash memory is not enough, you can delete the useless files in the flash memory
before software downloading.
z No power-breaking is permitted during software loading.
Remote Loading Using TFTP
The remote loading by using TFTP is similar to the remote loading by using FTP. The only difference is
that it is TFTP that you use when loading software to the switch. In this case, the switch can only be
used as a TFTP client.
To Next Page
Loading...
Need help?
General