1-17
# Configure traffic behavior b_ market to deny matching packets.
[Switch] traffic behavior b_market
[Switch-behavior-b_market] filter deny
[Switch-behavior-b_market] quit
# Configure QoS policy p_rd to use traffic behavior b_rd for class c_rd.
[Switch] qos policy p_rd
[Switch-qospolicy-p_rd] classifier c_rd behavior b_rd
[Switch-qospolicy-p_rd] quit
# Configure QoS policy p_market to use traffic behavior b_market for class c_market.
[Switch] qos policy p_market
[Switch-qospolicy-p_market] classifier c_market behavior b_market
[Switch-qospolicy-p_market] quit
# Apply QoS policy p_rd to interface GigabitEthernet 2/0/2.
[Switch] interface GigabitEthernet 2/0/2
[Switch-GigabitEthernet2/0/2] qos apply policy p_rd inbound
[Switch-GigabitEthernet2/0/2] quit
# Apply QoS policy p_market to interface GigabitEthernet 2/0/3.
[Switch] interface GigabitEthernet 2/0/3
[Switch-GigabitEthernet2/0/3] qos apply policy p_market inbound
IPv6 ACL Configuration Example
Network Requirements
As shown in Figure 1-2, a company interconnects its departments through the switch.
Configure an ACL to deny access of the R&D department to external networks.
Network Diagram
Figure 1-2 Network diagram for IPv6 ACL configuration
Configuration Procedure
# Create an IPv6 ACL 2000.
<Switch> system-view
[Switch] acl ipv6 number 2000
[Switch-acl6-basic-2000] rule deny source 4050::9000/120
[Switch-acl6-basic-2000] quit
# Configure class c_rd for packets matching IPv6 ACL 2000.
[Switch] traffic classifier c_rd
[Switch-classifier-c_rd] if-match acl ipv6 2000
[Switch-classifier-c_rd] quit
# Configure traffic behavior b_rd to deny matching packets.
To Next Page
Loading...
Need help?
General
