To Next Page

To Previous Page

10-2

To do… Use the command… Remarks

Associate the class with the

traffic behavior in the QoS

policy

classifier

tcl-name

behavior

behavior-name

—

Exit policy view

quit

—

To an interface Applying the QoS policy to an interface

—

To a VLAN Applying the QoS policy to a VLAN

—

Globally Applying the QoS policy globally

—

Apply the

QoS

policy

To the control

plane

Applying the QoS policy to the control

plane

—

z Generally, the action of redirecting traffic to the CPU, the action of redirecting traffic to an interface,

and the action of redirecting traffic to the next hop are mutually exclusive with each other in the

same traffic behavior.

z You can use the display traffic behavior command to view the traffic redirecting configuration.

z A QoS policy that contains a traffic redirecting action can be applied only to the incoming traffic.

z To implement QoS policy routing successfully, ensure that the next hop address specified in the

redirect action exist and the outgoing interface is not a tunnel interface. If you fail to do that, the

matching traffic will be dropped.

Support of Line Cards for Traffic Redirecting

Table 10-1 shows the support of line cards for the traffic redirecting action for the inbound and

outbound traffic.

For line card categories and their description, see the installation manual for the S7500E series

switches.

H3C S7500E Series Configuration Guide

Other manuals for H3C S7500E Series