H3C S7500E Series Configuration Guide

6-5
Task Remarks
Configuring SP Queuing Optional
Configure WRR Queuing Optional
Configuring WFQ Queuing Optional
Configuring SP+WRR Queues Optional
Per-Queue Hardware Congestion Management
Configuring SP Queuing
Configuration procedure
Follow these steps to configure SP queuing:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter
interface
view
interface
interface-type
interface-number
Enter
interface
view or port
group view
Enter port
group view
port-group manual
port-group-name
Use either command
Settings in interface view take effect on
the current interface; settings in port
group view take effect on all ports in the
port group.
Configure SP queuing
qos sp
Optional
The default queuing algorithm on an
interface is SP queuing.
Display SP queuing
configuration
display qos sp interface
[ interface-type interface-number ]
Optional
Available in any view
Configuration example
1) Network requirements
Configure GigabitEthernet 2/0/1 to use SP queuing.
2) Configuration procedure
# Enter system view
<Sysname> system-view
# Configure GigabitEthernet2/0/1 to use SP queuing.
[Sysname]interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] qos sp

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English