H3C S7500E Series Configuration Guide

1-6
Task Remarks
Creating a Time Range Optional
Configuring an IPv4 basic ACL
Configuring an IPv4 advanced ACL
Configuring an Ethernet Frame Header ACL
Copying an IPv4 ACL Optional
IPv6 ACL configuration task list
Complete the following tasks to configure an IPv6 ACL:
Task Remarks
Creating a Time Range Optional
Configuring an IPv6 basic ACL
Configuring an IPv6 Advanced ACL
Configuring an Ethernet Frame Header ACL
Copying an IPv6 ACL Optional
Configuring an ACL
Creating a Time Range
Follow these steps to create a time range:
To do… Use the command… Remarks
Enter system view
system-view
––
Create a time range
time-range
time-range-name
{ start-time
to
end-time days
[
from
time1 date1 ] [
to
time2
date2 ] |
from
time1 date1 [
to
time2 date2 ] |
to
time2 date2 }
Required
By default, no time range exists.
You may create time ranges identified with the same name. They are regarded as one time range
whose active period is the result of ORing periodic ones, ORing absolute ones, and ANDing periodic
and absolute ones.
You may create a maximum of 256 uniquely named time ranges, each with 32 periodic time ranges at
most and 12 absolute time ranges at most.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English