H3C S7500E Series Configuration Guide

1-7
Configuring a Basic ACL
Configuring an IPv4 basic ACL
IPv4 basic ACLs match packets based on only source IP address.
Follow these steps to configure an IPv4 basic ACL:
To do… Use the command… Remarks
Enter system view
system-view
––
Create an IPv4 basic ACL and
enter its view
acl number
acl-number [
name
acl-name ] [
match-order
{
auto
|
config
} ]
Required
By default, no ACL exists.
IPv4 basic ACLs are numbered in
the range 2000 to 2999.
You can use the
acl name
acl-name command to enter the
view of an existing named IPv4
ACL.
Configure a description for the
IPv4 basic ACL
description
text
Optional
By default, an IPv4 basic ACL has
no ACL description.
Set the rule numbering step
step
step-value
Optional
5 by default.
Create or edit a rule
rule
[ rule-id ] {
deny
|
permit
}
[
fragment
|
logging
|
source
{ sour-addr sour-wildcard |
any
} |
time-range
time-range-name |
vpn-instance
vpn-instance-name ]*
Required
By default, an IPv4 basic ACL
does not contain any rule.
To create or edit multiple rules,
repeat this step.
Note that the
logging
and
vpn-instance
keywords are not
supported if the ACL is to be
referenced by a QoS policy for
traffic classification.
Configure or edit a rule description
rule
rule-id
comment
text
Optional
By default, an IPv4 ACL rule has
no rule description.
Note that:
z You can only modify the existing rules of an ACL that uses the match order of config. When
modifying a rule of such an ACL, you may choose to change just some of the settings, in which
case the other settings remain the same.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English