119
Figure 209 Completing the configuration
Configuring RAID arrays in legacy mode
The storage controllers in this section support legacy mode but do not support the management
interface in legacy mode.
Downloading and installing StorCLI
This section introduces the download and installation steps of the OS command line tool. You can
use the OS command line tool to manage storage controllers during normal server operation
without restarting the server.
Downloading StorCLI
1. Access
https://www.h3c.com/cn/BizPortal/DownLoadAccessory/DownLoadAccessoryFilt.aspx
.
2. Download the installation package and release notes for the corresponding storage controller
firmware as instructed.
3. Decompress the installation package to obtain the StorCLI tool package for different operating
systems.
Installing StorCLI
See the release notes to install StorCLI for the corresponding operating system.
Commonly-used commands in StorCLI
This section describes the usage and examples of commonly used commands in StorCLI. You can
use the OS command line tool to manage storage controllers during normal server operation
without restarting the server.
To Next Page
Loading...
Need help?
General
