6
Storage controller HBA-H460-M1 FW1.04 can be
installed successfully on an RHEL OS but the
system prompts installation failure
Symptom
The HBA-H460-M1 storage controller with version FW1.04 can be installed successfully on an RHEL
OS but the system prompts installation failure.
Solution
To resolve the issue:
1. Install the aacraid drive on the RHEL OS.
2. Add a space before and after the aacraid field in /etc/dracut.conf.d/aacraid.conf, and then
save the configuration.
Figure 242 Adding spaces
3. Install the smartpqi driver.
4. Reboot the server and verify that the smartpqi driver has been installed successfully.
5. If the issue persists, contact H3C Support.
Bluescreen or kernel error occurred when BIOS
NUMA is enabled and IMC0 and IMC1 for CPU 1
or CPU 2 are disabled
Symptom
A blue screen or a kernel error occurred after a server reboot when the following conditions are met:
The operating system is installed on the logic disk of the storage controller.
BIOS NUMA is enabled and IMC0 and IMC1 for CPU 1 or CPU 2 are disabled.
To Next Page
Loading...
Need help?
General
