H3C WX3500H Series Installation Guide

19
Figure 17 Connecting a DC power cord (WX3540H)
Verifying the installation
Before powering on the device, verify the following information:
• The correct power source is used.
• The grounding cable is securely connected.
• The console cable and power cord are correctly connected.
• All the interface cables are cabled indoors. If any cable is routed outdoors, verify that the socket
strip with a lightning protector for network ports has been correctly connected.
Powering on the device
This section uses the WX3510H access controller as an example.
1. Power on the device. The device initializes its memory and runs the BootWare. The following
information appears on the terminal screen:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Press Ctrl+T to start heavy memory test
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing......Done.
****************************************************************************
* *
* H3C WX3510H BootWare, Version 5.09 *
* *
****************************************************************************
Copyright (c) 2004-2017 New H3C Technologies Co., Ltd.
Compiled Date : Apr 21 2017
CPU Type : 1000MHz Multi-core Processor
Memory Type : DDR3 SDRAM
Memory Size : 4096MB
Memory Speed : 1333MHz
BootWare Size : 768KB
Flash Size : 16MB

H3C WX3500H Series Specifications

General

Brand	H3C
Model	WX3500H Series
Category	IP Access Controllers
Language	English