Safety
3
1.3 Setup Safety
Refer to the Operation chapter of this manual for more information about setup procedures.
WARNING: Always press [EMERGENCY STOP] on the lathe before you put your
hands inside the Bar Feeder enclosure. Unexpected rapid motion can
occur and cause injury.
Only a trained user may load and adjust the machine to feed bars. During setup, be aware
of these pinch points:
• All parts of the moving mechanism. This includes the pusher assembly, spaces
inside the enclosure, and near the bar lifter and bar positioner arms.
• The area between the bar and the lathe.
• The area between the charging tray and the transfer tray.
• Rolling bar stock can also pinch fingers.
1.4 Operational Safety
WARNING: The area between the Bar Feeder and the lathe is hazardous. Always
press [EMERGENCY STOP] before you put anything between the Bar
Feeder and the lathe.
Before you run a program, always close the setup lid.
96-8913A.book Page 3 Monday, May 18, 2015 7:55 AM
To Next Page
Loading...
