Maintenance
37
Chapter 6: Maintenance
6.1 Maintenance
WARNING: Press [POWER OFF] on the lathe before you do maintenance tasks.
The Haas Bar Feeder requires little regular maintenance for optimal operation.
• Apply grease to the push rod and bushing. Manually move the push rod back and
forth to spread the grease and check for binding. Do this approximately (1) time per
month, or when the push rod is dry.
• Approximately (1) time per month, align the grease fitting in the linear guide truck with
the hole in the enclosure and apply (2) strokes from a grease gun.
F6.1: [1] Linear Guide Lubrication Access
• Clean the transfer tray.
• If a feed problem occurs, look for obstructions in the bar path before you continue
operation. Check for wear or debris in the spindle liner, and replace it if necessary.
96-8913A.book Page 37 Monday, May 18, 2015 7:55 AM
To Next Page
Loading...
