Bar Feeder Setup
8
3.1.1 Bar Feeder Positions
Feed / Auto Position: This is the Bar Feeder’s normal operating position. You can
command Bar Feeder motion at reduced speed with the lid open. In this position, you can
set up your bar feed application, check and adjust tray height alignment, and run your
application.
Lockout / Lathe Setup Position: Press the release pedal [1] at the base, and then push
the Bar Feeder back. This mode disables all Bar Feeder motion. With the Bar Feeder in this
position, you have easy access to change spindle liners, clean the coolant collector, or do
other tasks on the lathe spindle.
96-8913A.book Page 8 Monday, May 18, 2015 7:55 AM
To Next Page
Loading...
