Programming
27
Chapter 5: Programming
5.1 Program Examples
This section has (3) program examples.
• Example 1 calls a subprogram in the G105 command to cut off the part. This
programming style is most appropriate for solid stock where the cutoff program must
cut to the centerline.
• Example 2 includes the cutoff in the part program. This programming style is most
appropriate when the finished part has a hole through the center, and the cutoff
program does not have to cut to the centerline.
• Example 3 describes a double push. This programming style is most appropriate to
machine a length of bar shorter than the full part length, and then push to the full part
length.
CAUTION: The sample programs in this manual have been tested for accuracy,
but they are for illustrative purposes only. The programs do not define
tools, offsets, or materials. They do not describe workholding or other
fixturing. If you choose to run a sample program on your machine, do
so in Graphics mode. Always follow safe machining practices when
you run an unfamiliar program.
96-8913A.book Page 27 Monday, May 18, 2015 7:55 AM
To Next Page
Loading...
