Haas Bar Feeder - Chapter 3: Operation; 3.1 Bar Feeder Setup

Operation
7
Chapter 3: Operation
3.1 Bar Feeder Setup
Bar Feeder setup consists of these tasks:
• Lathe Setup
– Install the correct spindle liner for your application.
– Set up the correct workholding for a bar feed application.
•Bar Setup
– Load the bar stock.
– Adjust the charging tray angle (if necessary).
– Adjust the transfer tray height for the bar diameter.
– Install the correct push rod.
– Set up the bar feed variables.
F3.1: Bar Feeder Parts Overview
1. Charging Tray
2. Push Rod
3. Set-up Lid Handle
4. Push Rod Storage
5. Load Mechanism
6. Transfer Tray Adjustment Wheel
7. Release Pedal
8. Spindle Liner Storage
9. Bar Pusher
1
243
5
6
7
8
9
96-8913A.book Page 7 Monday, May 18, 2015 7:55 AM