Bar Feeder Setup
16
2. Press [PAGE UP] or [PAGE DOWN] to find the BAR FEEDER page.
3. Highlight the variable that you want to edit.
4. Type the value and press [ENTER].
Example:
#3100=2.150 (2.0" long part + 0.125" cutoff tool width + 0.025" facing allowance)
#3101=2.5 (2.5" of stock pushed past face of the collet)
#3102=3.0 (3.0" of material to clamp. During subsequent bar feeds, the machine will not
push the bar farther than a safe clamp position.)
Push Rod Clearance for #3102
CAUTION: Make sure that the push rod maintains 1/4" (6.4 mm) of clearance
between it and the collet chamfer. This clearance is necessary to
make sure that the push rod does not come in contact with collet
clamping surfaces.
To set push rod clearance:
1. Set macro variable #3102 MIN CLAMPING LENGTH to 1/4" (6.4 mm) from the collet
clamping surfaces.
F3.8: Minimum Clamping Length: [1] Push Rod, [2] Collet, [3] Workpiece
CAUTION: This diagram is for reference only. Workholding varies in form and
function. It is your responsibility to keep the push rod 1/4" away from
workholding surfaces.
96-8913A.book Page 16 Monday, May 18, 2015 7:55 AM
To Next Page
Loading...
