111
Section 16 Accessories and Spare Parts
16.1 Instrument
16.2 K1200 sensor
Important Note: The shelf-life of the K1200 LDO spot is 2 years prior to first use.
Part No. Description
32531.03 Ethernet cable for wall and panel instruments including connectors, length = 3m
32531.10 Ethernet cable for wall and panel instruments including connectors, total length = 10 m
32531.20 Ethernet cable for wall and panel instruments including connectors, total length = 20 m
32534.03 PROFIBUS-DP cable including SUB-D 9 female connector (length = 3 m)
32534.MM
PROFIBUS-DP cable including SUB-D 9 female connector, total length = MM, price added per meter
of length greater than 3 m
32959A Converter RS232/RS-485
32963 Wall mounting kit
32964 Panel mounting kit
32965 Locking key for wall instruments
32970 Cap to protect USB connector
32972 Pipe mounting kit for wall instrument
32973 PROFIBUS-DP upgrade kit (includes board and software key)
32975 Power supply connector (10-30 VDC) for panel and wall instruments
33015 Pressure reducer for calibration gas bottles with 0.1 L/min. flow, 5/8" x 18 connection, max 70 bar
33092 Measurement board for K-type and M-type sensors
DG33263 IP65 sealing kit for 410 and 510 panel instruments
LQV161.52.20000 Thermal printer USB for 410/51x controller (EU)
LQV161.53.20000 Thermal printer USB for 410/51x controller (USA)
LQV161.66.20000 Thermal printer USB for 410/51x controller (AUS/NZ)
LQV161.80.20000 Thermal printer USB for 410/51x controller (CN)
LQV161.82.20000 Thermal printer USB for 410/51x controller (UK)
LZP273 Thermal printer paper (4 rolls)
Part No. Description
K1200-S00
Luminescent oxygen sensor for on-line water applications, low range 0-2000 ppb, 28mm
ORBISPHERE fitting
K1200-S00H
Luminescent oxygen sensor for on-line water applications, high range 0-40 ppm, 28mm
ORBISPHERE fitting
32510.03 Sensor cable (3 m) to connect K1200 type sensors with ORBISPHERE 410/510 instruments
32510.05 Sensor cable (5 m) to connect K1200 type sensors with ORBISPHERE 410/510 instruments
32510.10 Sensor cable (10 m) to connect K1200 type sensors with ORBISPHERE 410/510 instruments
32510.15 Sensor cable (15 m) to connect K1200 type sensors with ORBISPHERE 410/510 instruments
32510.20 Sensor cable (20 m) to connect K1200 type sensors with ORBISPHERE 410/510 instruments
33087 O-ring kit for 28 mm K1200 type sensors
33103 K1200 spot mounting tool
28129 Protection cap for 28 mm sensors
K1200-H High level spare optical spot for K1200 sensors
K1200-L Low level spare optical spot for K1200 sensors
To Next Page
Loading...
Need help?
General
