89
Communication Menu
10.5.1 Install ferrite on the printer cable
Refer to the following steps for the ferrite installation on the USB printer cable included with the
LQV161.xx.20000 printer:
10.5.2 Printer error messages
Note: Cyclic measurement mode is automatically disabled when an error occurs. After the error is
corrected, reactivate the cyclic mode in the report configuration option if cyclic measurements are required.
Error message Meaning
Printer not available
Indicates that no printer has been detected. Check that the printer is
connected to the USB-A port and is powered on.
Paper out
Indicates that the printer is out of paper. In cyclic mode, it is necessary to
activate cyclic printing after reloading paper in the printer. In other modes,
printing can be restarted directly.
Unknown error
An unidentified error has been detected that prevents printing. If this error
occurs, refer to the printer User Manual to identify the cause of the problem.
To Next Page
Loading...
Need help?
General
