Section 8 Additional options
The following options can be added to the analyzer to increase performance:
• Reagent pump - 2 point automatic calibration
• Reagent pump - 1 point automatic calibration
• Reagent pump - Sample conditioning 1
• Reagent pump - Sample conditioning 2
• Chemical cleaning
• Dilution system
• External sample measurement or automatic calibration
• Heating system
• Extra channel
• Reagent canister kit
Figure 10 Option locations on rear panel
1 Reagent pump 4 External sample pump or automatic
calibration (1 point version)
7 Chemical cleaning
2 Reagent pump or automatic
calibration (2 point version)
5 Control valve for the dilution system
3 Reagent pump or automatic
calibration (2 point version)
6 Extra channel
Installation instructions for these additional options are described in the following
sections.
N O T I C E
A cable gland is provided for each option that must be connected inside the analyzer. The cable
glands are designed so that the cable shields attach directly to the analyzer housing as a ground.
W A R N I N G
To conform with security standards and to respect the EMC compliancy of the analyzer, follow the
procedures defined in Wiring procedures and cable preparation on page 12 for all connections to
the electronic unit of the analyzer.
37
To Next Page
Loading...
