Section 10 User configuration
User configuration
Default value User value Date
ELECTRODE
NAME Name GLASS
Slope Slope +059.16
Uiso Isothermal potential +0000.0 mV
E Reference potential +0000.0 mV
C Reference concentration 10E-8
OPTION
AUTOMAT. CAL YES/NO Automatic calibration NO
AUTO. CAL 1PT/2PTS Type of automatic calibration 2 PTS
With sample / With rinse water Calibration with sample or rinse water With sample
PULSE PUMP YES/NO Calibration with pulse pump NO
Flow: XX.X ml/mn or l/puls Flowrate of the pump 2 ml/minute
Cell Vol.: XXX.X ml Volume of the cell 100 ml
STD ADDITION Measurement with a known addition NO
CLEANING YES/NO Chemical cleaning NO
SAMPLE COND YES/NO Chemical conditioning NO
MANUAL YES/NO External sample measurement NO
SAMPLE TIME Sample injection time 10 seconds
HEATING YES/NO Regulation in temperature NO
Tc Temperature value 25°C
DILUTION YES/NO Dilution NO
2CHANNELS YES/NO Measurement of 2 different samples NO
ADJUST Iout
OUT 4-20/0-20 mA Output current 0-20 mA
Minimum value corresponding to 0 mA 0
Value 4 mA 795
Value 20 mA 3896
UNIT
ppb/ppm/USER Unit ppb
CLEANING: chemical cleaning
CLEAN. FREQ: XXX Number of measurements between cleaning
cycles
5
SPRINKLER t: XXXs Duration of the cleaning water sprinkler 5 seconds
REAG. INJ. t: XXXs Duration of cleaning solution injection 5 seconds
RESIDENC. t: XXXs Length of time the cleaning solution remains in
the reactor
5 seconds
53
To Next Page
Loading...
