Hach SIGMA 900 - Section 6 Programming Worksheets - Storm Water Setup; Stormwater Setup Sheet

Page 58
Stormwater Setup Sheet
8837prgwrk.fm
Section 6
6.3 Stormwater Setup Sheet
Press and hold CLEAR ENTRY key for several seconds.
Name: Date: SN: ID#:
1. Level Control?
Press
YES to activate Storm Mode.
2. Storm Mode?
Press
YES to get into storm program.
3. First Flush Interval = _______ min.
4. # of Bottles = __________
5. Set Timed Interval = _______ min.
Press
NO to maintain first flush interval for the rest of the first flush.
6. Samples/bottle or Bottles/sample?
Press
YES to select mode.
Samp/Bottle = _______
or Bottle/Sample = _______
7. Change First Flush Volume?
YES or NO?
If
YES then:
See Volume Calibration Sheet.
8. Sample Time Limit?
YES or NO?
If
YES then:
Limit: ________ min.
9. Special Output?, Sample Output?, Event Output?, Fault Output?, or Trouble Output?
If
YES then:
Press the
NO key until desired output is displayed.
Press
YES to Select Special Output.
If
NO then:
Program continues at line 18 of Main Sampler Program.