6.3.1 Sequences
Sequences are used to create complex scenarios for executing functions conditioned or not by sensor states.
A sequence is characterized by:
- One or more triggers,
- One or more conditions,
- One or more actions.
A trigger makes it possible to evaluate, in a simple and fast manner, an event before carrying out a test of the
condition.
Trigger type: on time schedule - Cyclic - On KNX event - On variable change - On device change - On
measurechange- On service change.
A condition allows complex evaluation of different events in a more precise way. It is evaluated only when one of the
triggers is valid. The evaluation can also be carried out using logical operator (AND, NAND, OR, NOR, XOR and
XNOR)
An action is an operation on an output device. This device can be a device of the installation, a device group, another
sequence or various other objects (Logic / Boxes / Tools).
The maximum number of allowed sequences is 100.
Click on new in the Sequence section to create a new sequence.
• rename the sequence directly in the field on the top right.
You can add a description if necessary.
• click Add a trigger to start configuring the sequence.
• select a trigger and configure the properties
• click OK to save your preferences.
• click Add a condition for a more accurate evaluation of the sequence.
• select one or more conditions and configure the properties
• click on Save to save your preferences.
• click Add an Action to configure the action performed by the trigger.
• select the devices or groups concerned.
• click on Edit to set the action to execute
• add other actions if necessary.
To Next Page
Loading...
