2 GENERAL DESCRIPTION
2.1 Introduction to the system
domovea is the command and display software for KNX and IoT installations. It enables access to all of the home
automation functions from the computer terminals (smartphone, tablet, PC, etc.) in the home. In addition to the usual
controls, there are new functions for comfort and security: triggering sequences (sequence of programmed or
immediate actions), changing the configuration of the house according to events or periods, using images to visualise
the correct execution of past or current commands, with a single click.
2.2 System overview
The domovea system is comprised of three modules:
- The Server: A TJA670 or TJA470, a physical interface between the KNX bus and the local network in the
home.
- The Client: This software is the client interface. It must be installed on a smartphone, tablet or PC.
- The Configurator: This software is used to configure and program the client interface. It enables access to the
server from a PC, smartphone or tablet via the hager Pilot application or a web browser.
The following diagram describes the physical architecture of a domovea installation:
To Next Page
Loading...