2.8.2 Connection with a remote network
(Only with TJA470 Domovea Expert)
In order to establish a remote connection using the KNX / IP interface, the following conditions must be fulfilled:
- Administrator rights are transferred (see chapter 5.2.2.1)
- Installer access is activated (see chapter 5.2.2.2)
- The KNX/IP secure process is running in the ETS project (see chapter 2.7)
- Remote access is activated (see chapter 5.2.1.3)
Downloading the application:
- Download the domovea secured proxy app from knx.org using your KNX account.
- Download the product license for the domovea secured proxy app
Please have your ETS key number (KNX-xxxxxxxx) with you, in order to generate a licence for the
application during the download.
Installation of the application in ETS
- Insert the ETS licence key
- Start ETS
- Click on the Apps section in the lower right corner.
- Select Compatibility Mode App to activate the application.
- Restart ETS to enable the application
- Click on the Apps section in the lower right corner.
- Click on + and select the domovea secured proxy app x.x.x.x.etsapp file that you have previously
downloaded.
- Restart ETS to enable the application
Installation of the license
- In ETS, click on the License section in the lower right corner.
- Click on + and select the domovea secured proxy app- xxx.license file that you have previously
downloaded.
KNX project
- Open the KNX project secured beforehand
- Select the domovea device
- Enable Secure Tunnelling in the device properties in the Settings tab
- Go to the Apps tab and select the domovea secured proxy app
- Enter the email address and password for your My Hager account
- Select from the list the domovea server set up in your project and click Start.
To Next Page
Loading...
