8/64 CMp | Safety instructions
Bosch Rexroth AB, RE 15409 Version 08.2022,
2.5 General safety instructions
• Observe the regulations for accident prevention and environmental protection.
• Comply with the local safety provisions and regulations of the country in which
the product is used.
• Make sure to use Rexroth products in perfect working order.
• Strictly observe all instructions on the product.
• Persons, who assemble, operate, disassemble or maintain Rexroth products
must not consume any alcohol, drugs or pharmaceuticals that may affect their
ability to respond.
• Use exclusively accessories and spare parts explicitly approved by the
manufacturer to avoid accidents due to improper accessories and spare parts.
• Strictly observe the technical data and ambient conditions specied in the
product documentation.
• Inadequate products installed or used for safety-relevant applications may
produce unintended operating behavior and result in product or property
damage. For this reason, use a product in safety-relevant applications only on
condition that such use is specied and allowed in the corresponding product
documentation.
• Prior to commissioning the product, make sure that the end product (e. g. a
machine or line), into which Rexroth products are integrated, perfectly complies
with the country-specic provisions, safety regulations and standards applicable
to its use.
2.6 Product and technology-related safety messages
Specify the safety instructions directly related to the product or the technology of
the respective eld of application.
Check which regulations and standards apply to the product, e. g. EMC, pressure
vessels, wind turbines or electric drives. Dene technology and product-specic
notices with signal word, type and source of risk, consequences and precautions
how the hazard can be avoided.
If you deactivate safety devices of the product for functional reasons, you have
to make sure that the mandatory level of safety is achieved in another way in
accordance with the relevant regulations.
CAUTION
Improper routing of cables and lines!
Tripping hazard and damage to equipment!
f Lay cables and lines so that they can not be damaged, and in the case of a
solution with long cables between drives place these in a way that nobody can
trip over them.
Damaged cables!
Risk of injury or serious injury, damaged to equipment!
f If the product is damaged, (Cables e.g) never touch it or perform any kind of
repair unless the power is turned off.
2.7 Personal protective equipment
The personal protective equipment is the responsibility of the user of any
Hägglunds products.
To Next Page
Loading...