58
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
(2) Reading method of inspection code
Press the check button, the number (when controlling in group, it will be address in the group) of indoor unitgroup with inspection code will be displayed on the right side of the "setting time" display part, and the faultinformation of 2 inspection codes x 16 sets will be displayed on the display part of "setting temperature". When displaying "filter", after the indoor unit number needing cleaning appears on the right side of the displaypart of setting temperature, display the inspection code as per the following method (each indicates 3 seconds):
<7-segment display>
Decimal
system
Hexadecimalsystem
<Filter information>
(For example) When the filter information of No. 1 and No. 15 unit controlled in group is sent out
<Check information>
(For example) When the room temperaturesensor of No. 1 unit has faultWhen No. 15 unit starts, indoor heatexchanger (TC1) has fault, then outdoorserial communication has fault
(For example) When thereis not any detectioninformation
Number
of unit
group
self-
checking
Inspection
code first
checked out
Inspection
code lastchecked out
after 3seconds
Number
of unit
group
self-
checking
Number
of unit
group
self-
checking
Number
of unit
group
self-
checking
Filter
screen
Filter
screen
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
