C. Centrol controller
59
(1) Check display operation
Pressing check button can confirm inspection code. Refer to item 2 for reading method of inspection code:
Check button
Reset button
LCD displays the reason of "standby"
Indoor unit group with cool mode being set due to prior to heat control
When the capability of indoor unit group is overloaded
Selection of indoor unit group whose running mode is opposite to the running
mode (cold/heat) and switch setting content of outdoor unit
When the phase sequence of power wiring of outdoor unit is wrong
Press it for 0.5 second to display inspection codePress it for 3 seconds to reset the indoor unit (whenthe indoor unit is in the state of stopping runningdue to its abnormality)Press it for 10 seconds to clear inspectioninformation in addition to resetting the indoor unit.When using it, press the button in thehole, the power of remote control unitwill be reset
(clear all information)
1
MONITOR SET
MODE
®
CENTRAL
C
F
UNIT ALL
ON
OFF
2 3 4 5 6 7 8
9
10 11 12 13 14 15 16
FAN ONLY
COOL
DRY
HEAT
AUTO
HIGH
MED
LOW
FIX
AUTO
FAN
LOCKED
STANDBY
FILTER
TIMER
CENTRAL
TEMP CHECK
LOUVER
MANUAL
1
2
CONTROLLER
MONI/SET UNIT SEL ALL
ON OFF CENT/LOCK
MODE FAN LOU
TEMP TIMER
CHECK FILTER
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
