Hoppers
• Select
• Select
• Select
The screen should look like this:
Using the pull down will show your options like the example below:
Select which coin type you are putting into the hopper.
*NOTE: Coin types may differ depending on the Region selected.
**NOTE: Hopper and coin types are usually set at the factory.
There are 2 coin hoppers in the HTK. Typically, the left one is hopper 1 and the right is hopper 2. You can
verify how they are setup by checking the dip switches on the hopper. See dip switch configuration
below:
To Next Page
Loading...
