Hamilton ExpressPass RFID System
• Select
• Select
• Select
• Select
The screen should look like this:
Enable: Turn ON to enable the use of the Hamilton RFID
IP Address: This refers to the IP address of the RFID reader in the same lane as the HTK. This address it
typically set during installation of the RFID equipment and is rarely changed. It’s important to make note
of the readers IP address for two reasons. First you need to enter that address here in the HTK
configuration so it knows which reader to communicate with. And also, you will need to know that
address in case it’s ever necessary to log into the reader to make changes to its configuration settings
(for example to adjust the read strength setting).
To Next Page
Loading...
Need help?
General
