Hamilton HTK User Manual

Pi
ng the ip address you want to put the HTK on before setting the addresses. Just type in the cmd
prompt ping 192.168.1.50, or whatever ip you want to check. If there is a response in ms, that address
is being used, try another.
Once you know what ip to use, right click on the computer in the lower right hand corner,
This will come up:
Left click on Open Network and Sharing Center.
That will bring up this screen:
Document #101-0243
15
02/01/18

Hamilton HTK Specifications

General

Brand	Hamilton
Model	HTK
Category	Digital Signage
Language	English