In
Service: When using a separate wash in service signal the drop down selects the state of this signal
when the system is in normal operation. The opposite state of this signal will put the system out of
service. If not using this signal leave it set to Passive.
Out of Service Delay: Here you can determine in seconds, how long before the HTK goes out of service
when we get an inhibit signal from the car wash on the wash in service input.
Once you have completed these settings, click activate changes to save the settings. Then click the back
button to the previous page. Continue to click Back until you are at the page you need.
To Next Page
Loading...
