Only transfer [End] segments
Example: When the decoding information is "1234567890123ABC", output the last 13 bytes "4567890123ABC".
1. By checking the character table, the corresponding hexadecimal character of decimal data "3" is "03".
2. Ensure the setting code is enabled, if not, please scan setting code of “Enable setting code”.
3. Scan “Interception Length N after modified”.
4. Scan data setting “0”, “3” in turn.
5. Scan “Save”.
6. Scan “Only transfer the [End] segments.
Only transfer [Center] segments
Example: When the decoding information is "12345678900123ABC", output the center 4 bytes "0123".
1. By checking the character table, the corresponding hexadecimal character of decimal data “3” is “03”.
2. Ensure the setting code is enabled, if not, please scan setting code of “Enable setting code”.
3. Scan “Interception Length N after modified”.
4. Scan data setting “0”, “3” in turn.
5. Scan “Save”.
6. Scan “Interception Length M before modified”.
7. Scan data setting “0”, “A” in turn.
8. Scan “Save”.
9. Scan the "Transfer only the Center segment" setting code.
To Next Page
Loading...
