16
11. Mix a small amount, approximately 1/4 oz., of 6-minute
epoxy and apply it to one of the aileron servo supports between
the two tabs. Position the aileron servo tray in place as shown
and lightly spread epoxy along the joint between the aileron
servo tray and the aileron servo support.
Note: Thick CA can be used instead of epoxy for this
procedure.
12. Repeat this procedure for the opposite aileron servo
support, making sure the aileron servo supports and the servo
tray remain perpendicular to one another. Allow the epoxy, or
CA, to dry completely before proceeding to the next step.
CONTINUED
Section 3: Installing the Aileron Servo Tray
To Next Page
Loading...
