69
Motor use notice
The motor is only used in the work condition specified on the nameplate and in the
operational manual. Otherwise there is danger of electric shock, injure and device
damage.
Parts of stator have been adjusted
Keep clean and dry around the motor, place no other material on its inner or outer.
Wipe off the sand and other adhesion on the housing in order not to affect heat dissipation.
d.
Make sure the correct of input voltage grade.
If there is abnormal odor in use, park to check immediately.
The cabling between motor and controller should be as short as possible.
During motor travelling, if there happen electric leakage, speed drops suddenly, severely
vibrate, too hot with smoke, or electric contact sparking smoke, turn off the power
immediately for check.
Often check if the motor over heats.
Often check motor wiring contact screw for looseness, sparking smoke or insulation aging.
Do not repair with power on, do operate after power is off. Otherwise there may be danger.
Never use in the flammable and combustible environment, otherwise there may occur to
explosion, fire, electric shock, injure or machine damage.
Only person with professional knowledge and skill can transport, install, connect wire, run,
operate, maintain and repair. Otherwise there may occur to explosion, fire, electric shock,
injure or machine damage.
Do not put hand and goods at the motor mouth. Otherwise there is danger of electric shock,
injure, fire and device damage.
Never use damaged motor. Otherwise there is danger of injure and fire.
Never remould the motor without authorization.
To Next Page
Loading...
