EasyManua.ls Logo

HANGCHA CPCD15 - Page 17

HANGCHA CPCD15
149 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
immediately and the fault must be addressed
based on the engine fault code table.
Maintenance personnel can diagnose the faults
based on the fault indicator light (flashing code)
or connect the ECU diagnosis interface with the
diagnostic equipment to read the fault code
information stored in the ECU.
See the engine manual for details.
Cummins engine models: if this light turns on, it
indicates that one operating parameter of the
engine exceeds the engine safety limit and the
engine power is reduced, the engine should be
stopped for further inspection.
Neutral start indicator light (for
commutator-based forklift truck)
When the truck is temporarily stopped, the
direction lever should be in the neutral position;
with the lever in this position, the light turns on.
The truck can only be started when it is in
neutral.
The truck must not be in the neutral position
when driving downhill.
OPS indicator light (optional function)
When the light turns on, it indicates that the
driver is not on the driver's seat or is not sitting
properly. It turns off when the driver is seated
and buckled up.
Parking indicator light
When the light turns on, it indicates that the
parking brake is applied. In order to drive the
truck, the parking brake lever (e.g. hand brake
lever) should be released; when the brake is
released, the light turns off.
Caution
Driving the truck when the light is on
may cause damage to the engine, drive
system and other parts.
Major fault indicator light [for forklift trucks with
an electronically controlled engine]
Cummins engine models: if this light turns on, it
indicates that the engine has a serious fault and
that engine power is greatly reduced. If the
status remains the same and the engine
protection shutdown is enabled, this light will
flash for 30 seconds, warning the driver of an
impending shutdown event before the engine
stops.
Air filter alarm indicator light
When the light turns on, it indicates that the air
filter in the air intake system is blocked and the
truck must be stopped to clean the filter.
Seat safety belt alarm indicator light (optional
configuration)
When the light turns on, it indicates that the
driver is not properly buckled up.
Low brake pressure alarm indicator light
The indicator light in the 1.5t -3.5t forklift truck
is not operative.

Related product manuals