b
）
Apply anti-rusting oil to exposed parts that
may start to rust such as the piston rod and
shaft.
c
）
Parts such as vent plugs and air filters should
be covered to protect them from moisture.
d ） Start the forklift truck once a week. If the
cooling water is drained out, it should be refilled
with cooling water. Install the battery. Remove
the anti-rusting oil on the piston rod and shaft,
start the engine and warm up fully, run slowly
back and forth, operate the mast to raise and
lower, and tilt back and forth several times.
e
）
Forklift trucks should not be parked on
asphalt roads in the summer.
3. Operation of forklift trucks after
long-term storage
a ） Remove the anti-rusting oil from exposed
parts.
b
）
Drain the oil from the engine crankcase, drain
the gear oil or ATF in the drive axle housing and
hydrodynamic transmission (only for
hydrodynamic transmission forklift trucks), clean
the interior and add new oil.
c
）
Clear the foreign matter and water in the
hydraulic oil tank and fuel tank.
d）Remove the engine cylinder head, valve and
rocker arm shaft, and check whether each valve
clearance is normal.
e）Fill coolant to the specified scale line.
f
）
Charge the battery, mount it into the forklift
and connect the battery leads.
g）Carefully carry out the pre-start inspection to
check starting, forward, reverse, steering, lifting,
lowering, front and rear tilting.
g）Preheat the forklift truck.
To Next Page
Loading...
