7. Others
1.Fuses and relays
① Before replacing any defective fuse or relay,
please investigate the cause of failure.
② Replace the fuse with a new one of the
specified rating.
The forklift control unit is installed on the left
side of the engine inside the internal
combustion engine hood.
2. Tire replacement
Warning
When using an air compressor, as the
maximum output pressure of the air
compressor is higher than the specified
pressure of tire, the pressure setting
should be adjusted first; otherwise it may
cause a serious accident.
In order to ensure safety, the tire should
be placed in a protective frame during air
inflation.
Front tires
a）Park the forklift on level and solid ground.
b
）
Start the engine and raise the mast by
approximately 100 mm.
c）Place wooden blocks behind the rear wheels
to prevent the forklift from moving.
d ） Loosen each wheel nut 1-2 turns
counterclockwise.
e
）
Tilt the mast backward and place wooden
blocks at the sides of the outer mast.
f）Tilt the mast forward until the front wheels
are lifted off the ground.
Caution
Do not loosen the nuts until the front
wheels have been lifted off the ground.
g）Place wooden blocks on each front side of
the forklift frame to support the forklift and
then turn off the engine.
h ） Remove the wheel nuts and replace the
front wheels.
Caution
When removing the tire from the hub,
the rim bolts and nuts should not be
removed until deflating.
The wooden blocks should be solid and
sufficiently strong.
When the forklift is supported with
wooden blocks only, do not lie
underneath it.
i）Put on the nuts in sequence as shown in the
To Next Page
Loading...
