Caution
If the forklift truck has any damage or
faults, it should not be started before
repairing.
1. Start
Starting the diesel forklift truck
① Pull the shift lever in the neutral position.
②Start after rotating the starting switch to
“ ” position, and then put the key back to
“
┃
”.
Caution
If the truck fails to start within 5s, the
starting switch should be rotated to “O”
and the truck should be restarted after
an interval of 2 min.
If the truck fails to start three
consecutive times, the cause should be
investigated.
Caution
When the ambient temperature is lower
than -5℃, the key should be rotated to
the right in the “ ┃ ” position for
preheating; after the preheat indicator
light turns off, the key can be rotated to
“ ” for starting.
After the engine is started
①Preheat the engine for about 5min.
②Check the operating conditions of the
engine.
Caution
Diesel engine
Step on the accelerator to make it run at
intermediate speed after the diesel
engine is started; preheat the engine
without load.
a) Check the compression (no ignition) sound.
b) Check exhaust conditions.
c) Confirm that all indicator lights have turned
off.
d) Operate the multiway valve control lever
2-3 times throughout the process and
check the working conditions of the mast
after the engine is fully preheated.
2. Operation
a
）
Hold the steering wheel lever with your left
hand. Put your right hand on the steering wheel
gently to get ready for loading/unloading
operations.
b）When the distance between the fork bottom
and the ground is 15cm-20cm, the mast will tilt
backwards in place.
c）Look around the forklift truck to see if there
are any pedestrians and sound the horn.
Hydraulic drive forklift truck
a ） Step on the brake pedal and operate the
front/rear changeover switch.
b
）
Release the hand brake.
c ） When the brake pedal is released and the
accelerator pedal is depressed, the truck will
To Next Page
Loading...
