HANYOUNG NUX TD510 Series - Page 24

Programmable Temperature & Humidity Controller
22
▶ Individual control
No indicator setting.
Set IS1 to indicator.
IS1 disabled.
Set IS1 to indicator.
IS1 enabled.
No. Description
1 Displays state of SD card.
2 Runs hidden menu pane. Click the same to hide menu pane.
3 Go to operation 3 screen.
4 Go to main menu screen.
5 Switch channel (Ch.1 ↔ Ch.2)
6 Displays measurement(PV) of channel.
7 Displays unit of channel.
8 Displays heating control output(H.MV) of channel. (For heating/cooling control)
9 Displays cooling control output(C.MV) of channel. (For heating/cooling control)
10 Enter target setting value(TSV) for channel.
11 Enter current setting value(NSV) for channel. (Displayed during operation only).
12 Displays ascending/descending/holding state of channel.
13 Enter PID No. for channel.
14 Run/stop button.
15
Indicates input/output signal state.
Press it to display 2nd indicator pane.
(Up to 16 in 1 screen so up to 32 in total).
* Indicators of operation screen can be set in
[Main menu] – [System menu] – [System] – [Indicator].
16 Displays general operation state messages.
17 Displays operation time.
Fig. 19) Stop screen of constant-value operation 2(Ch.1)
Fig. 21) Stop screen of constant-value operation 2(Ch.2)
Fig. 20) Operation screen of constant-value operation 2(Ch.1)
Fig. 22) Operation screen of constant-value operation 2(Ch.2)