HANYOUNG NUX TD510 Series - Page 28

Programmable Temperature & Humidity Controller
26
▶ Individual control
▶ Menu pane
①
②
③
④
No. Description
1 Hold is enabled only during program operation and current setting value is maintained when executing.
2
Step is enabled only during program operation, and it ends current segment and then forcibly
goes to next segment.
3 Press User-defined button to run assigned relay in [Main menu] – [System menu] – [DO].
4 Go to DI state check screen.
그림 27) 문자 그림 28) 문자
Fig. 29) Stop screen of program operation 1(Individual control)
Fig. 31) Menu pane of program operation 1 screen(Concurrent control)
Fig. 30) Operation screen of program operation 1(Individual control)
Fig. 32) Menu pane of program operation 1 screen(Individual control)