HANYOUNG NUX TD510 Series - Page 30

Programmable Temperature & Humidity Controller
28
▶ Individual control
No indicator setting.
Set IS1 to indicator.
IS1 disabled.
Set IS1 to indicator.
IS1 enabled.
No. Description
15 Enter pattern No. for operation.
16 Enter seg No. for operation.
17 Displays applied PID No. of channel.
18 Displays pattern cycle state (Number of actual cycles/Number of set cycles).
19
Displays current segment and total number of segs of current pattern.
(Current segment No./Number of segments)
20
Displays elapsed and set time of current segment.
(Elapsed time of segment/Se time of segment).
21
Indicates input/output signal state. Press it to display 2nd
indicator pane. (Up to 16 in 1 screen so up to 32 in total).
* Indicators of operation screen
can be set in [Main menu] – [System menu] – [System] –
[Indicator].
22 Displays general operation state messages.
23 Displays operation time.
Fig. 37) Stop screen of program operation 2(Ch.1)
Fig. 39) Stop screen of program operation 2(Ch.2)
Fig. 38) Operation screen of program operation 2(Ch.1)
Fig. 40) Operation screen of program operation 2(Ch.2)