HANYOUNG NUX TD510 Series - Page 76

Programmable Temperature & Humidity Controller
74
- Screen to set relays for pattern/system alarms.
- If an alarm signal is transmitted, defined relay is ON.
- Screen to set relays for operations signals by channel.
1. Control signal
- Set Ch.1 and Ch.2 operation signal relays and delay.
2. Sensor disconnection
- Set Ch.1 and Ch.2 sensor disconnection signal relays and ON time.
3. Ascending section
- Set ascending signal relay and offset.
- Offset = Target setting value – Ch.1 or Ch.2 value
4. Holding section
- Set holding section relay and ON time.
5. Descending section
- Set ascending signal relay and offset.
- Offset = Target setting value + Ch.1 or Ch.2 value
▶ Alarm
▶ Ch.1/Ch.2
Fig. 128) DO - Alarm signal
Fig. 129) DO - Operation signal
Parameter Setting range Default
P. Alarm 1 - 4 Up to 0 - 32 0
S. Alarm 1 - 8 Up to 0 - 32 0