Hardi SMARTCOM ISOBUS UT SW A.2.2 Series User Manual

3 - Description
64
Menu 3.6.6 Safety Factor
This menu you can set the amount of risk that is acceptable until
the sprayer will align the steering, to avoid the sprayer is tipping
over.
Values that SmartCom takes into account for risk assessment are:
• Speed
• Turning radius
• Angle of the drawbar
€
DANGER! Decreasing this value may cause the sprayer to tip over!
The risk is set as a value in percent.
• 1% gives no safety. This is not recommended!
• 100% gives maximum safety.
• Default is 10%.
Menu 3.6.7 End-stop Calibration
This menu calibrates the steering so the SmartCom computer
knows its end-stops on AEON sprayers.
Menu 3.6.8 Disable align while reverting
In this menu it is possible to select whether the sprayer steering
shall align or not, when reversing an AEON sprayer.
Increasing value: Increases the safety when driving. The risk
of the sprayer tipping over is reduced.
Decreasing value: Increases the risk of the sprayer tipping
over. Be very careful when doing this!
Safety Factor
Increasing this value
increases the safety. With
100% best safety is achieved.
End-stop Calibration
Set wheelsteer end stop
position manually
degree
Disable align while reverting
Alignment enabled
Alignment disabled
Menu

Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Specifications

General

Brand	Hardi
Model	SMARTCOM ISOBUS UT SW A.2.2 Series
Category	Farm Equipment
Language	English