3 - Description
65
Menu 4 Toolbox
Menu 4.1 Service intervals: Hours until
Service intervals and a nozzle check are programmed into the
Controller. This makes it easier for the operator to remember the
service intervals.
From the factory, the Controller is set up with three service and a
nozzle check reminder.
Entering the above menu’s will display the hours remaining until next service. The importer or dealer may have added a
“Miscellaneous service” interval. If no interval is set, [Miscellaneous service not defined] is shown.
Press to register service or control, if displayed when switched on. The reminder will remain present until the
service interval is reset.
Menu 4.2 Service interval reset
To reset service interval, go to relevant interval menu and:
• Press to reset hour meter.
• Press to leave unchanged.
Service Interval Action
10hrs Check filters reset See sprayer instruction book, Maintenance.
50hrs Grease boom reset See sprayer instruction book, Maintenance.
250hrs Grease track and centre See sprayer instruction book, Maintenance.
Miscellaneous service Not defined from factory.
10hrs Check nozzles Check flow rate. Change nozzles if more than 10%
of rated flow.
Service interval: Hours until
Menu
10 hrs Check filters
10 hrs Check nozzles
50hrs Grease points
100hrs Tighten bolts
250hrs Misc. check
Work hours remaining for each
part until next service is
recommended
Service interval reset
Menu
Check filters reset
Check nozzle reset
Grease points reset
Tighten bolts reset
Misc. check reset
Press Enter to reset hour
counter, ESC to leave
unchanged
To Next Page
Loading...
