ENGLISH
21
• The volume level of each channel can be adjusted easily with the test tone function.
Adjusting each channel level with test tone
• The test tone mode is displayed and will be heard from the
speaker of each channel for 2 seconds as follows:
FL C FR SR
Front Left Center Front Right Surround Right
SW SL
Subwoofer Surround Left
• When the speaker setting is "N (None or No)", the test
tone of the corresponding channel is not available.
NOTE:
The test tone function does not work as expected if :
• All the speakers are switched off.
• USB IN or 6CH DIRECT INPUT is selected as an input
source.
• If the unit is in the STEREO or the 2CH DOWNMIX
mode.
1. Enter the test tone mode. 2. For each channel, adjust the level as desired until the
sound level of each speaker is heard to be equally loud.
3. Cancel the test tone function.
• You can select the desired channel with pressing the /
buttons.
• The Virtual Surround Headphone mode simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel
surround sound through 2 channel headphones, just like listening from 5.1 channel speakers.
NOTES :
• Virtual Surround Headphone mode can be selected only when all the speakers are switched off.
• When listening to music files from the USB mass storage device, the Virtual Surround Headphone mode cannot be selected.
• Select the Virtual Surround Headphone mode.
• Then”VS HP” is displayed and the Virtual Surround
Headphone mode is selected.
• To cancel the Virtual Surround Headphone mode, press the
STEREO MODE button.
Listening in Virtual Surround Headphone mode
To Next Page
Loading...
Need help?
General
