ENGLISH
When selecting the SUBWOOFER mode
1. Press the / buttons to select the desired item. 2. Press the / buttons to set the selected item as desired
• "SW " mode is effective only when program sources without LFE signals are played and "FRONT", "CENTER" or "SURR"
is set to "L" and "SUB- W" is set to "Y" on the SPK SET menu. (For details, refer to "SETTING THE SPEAKER SETUP" on
page 37.)
NORM : When the low frequency signals of channels set to "L" are reproduced from those channels only.
In this mode, the low frequency signals that are reproduced from the subwoofer channel is only the low frequency
signals of LFE (from the multi-channel sources that contains LFE (Low Frequency Effects) channel, also called the
".1" channel) and the channels set to "S".
SW : When the low frequency signals of channels set to "L" are reproduced simultaneously from those channels and the
subwoofer channel.
In this mode, the low frequency range expands more uniformly through the room, but depending on the size and
shape of the room, interference may result in a decrease of the actual volume of the low frequency range.
When selecting the SPEAKER mode
A : To switch the A speakers on.
B : To switch the B speakers on.
A+B : To switch the A and B speakers on.
OFF : To switch off all the speakers.
NOTE: When using the headphones for private listening, switch off all the speakers.
SETTING THE SYSTEM
34
• SPK(SPEAKER) : To switch the desired speakers on.
• SW (SUBWOOFER) : To select the desired subwoofer mode.
• TONE : To adjust the tone (bass and treble) as desired.
• RETURN : To return to the previous menu.
To Next Page
Loading...
Need help?
General
