5. CONNECTING 6 CH DIRECT INPUT
6. CONNECTING DIGITAL INs
7. CONNECTING SUBWOOFER PRE OUT
• To emphasize the deep bass sounds, connect a powered
subwoofer.
• The OPTICAL and the COAXIAL DIGITAL OUTs of the
components that are connected to CD, DVD, HDMI 1~ 3
and VIDEO 1 ~ VIDEO 2 of this unit can be connected to
these DIGITAL INs.
• A digital input should be connected to the components
such as a CD player, LD player, DVD player, etc. capable
of outputting DTS Digital Surround, Dolby Digital or PCM
format digital signals, etc.
• For details, refer to the operating instructions of the
component connected.
• When making the COAXIAL DIGITAL connection, be sure
to use a 75 Ω COAXIAL cord, not a conventional AUDIO
cord.
• Not all the commercially available optical fiber cords can
be used for the equipment. If there is an optical fiber cord
which cannot be connected to your equipment, consult
your dealer or nearest service organization.
NOTE : Be sure to make either a OPTICAL or a COAXIAL
DIGITAL connection on each component. (You
don’t need to do both.)
• Use these jacks to connect the corresponding analog
outputs of 6 CH decoder or DVD player with 6 CH output
for Dolby Digital or DTS, etc.
(For details, see the operating instructions of the
component to be connected.)
To Next Page
Loading...
Need help?
General
